btacleveland.blogg.se - Ip address for netgear router b90-755044-15

If you Select IPoA, the router will be able to detect the gateway IP address but you still need to provide the router IP address.ģ. If required, enter the Account Name and Domain Name from your ISP.Ģ. Select Use Static IP Address or Use IP Over ATM (IPoA-RFC1483 Routed) according to the information from your ISP. Wizard Detected Fixed IP (Static) Account Setup:ġ.

Click Test to test your Internet connection.

If a Secondary DNS Server address is available, enter it also.Ĥ. Enter the IP address of your ISP's Primary DNS Server. This information should have been provided to you by your ISP.Ģ. Enter your assigned IP Address and Subnet Mask. Wizard Detected IP over ATM Account Setup:ġ. Wizard Detected Dynamic IP Account Setup:Ĭlick Apply to set Dynamic IP as the connection method. This information should have been provided to you by your ISP. Wizard Detected PPPoA Login Account Setup:Įnter your login user name and password. Wizard Detected PPPoE Login Account Setup:Įnter the PPPoE login user name and password. Your ISP has already activated your DSL account. Note: If the Setup Wizard finds no connection, please check the physical connection of your devices, and make sure that Please follow the steps under the connection type detected by your router:

The Setup Wizard will report which connection type it has discovered, and then display the appropriate configuration page.

Click Setup Wizard on the top left corner, Select Yes for the Setup Wizard to detect the type of Internet connection and click Next.

Otherwise, a factory reset is needed to restore the router to factory defaults. To perform a factory reset, see Restoring a NETGEAR home router to the factory default settings.

Please try other passwords that you might have changed to. If the default username and password is not working, you might have changed the password.The username and password are case-sensitive.The default username is admin and the default password is password.You are prompted to log into the router.Open a web browser and type the router's IP address which would be either or in the address bar and press Enter.Use an Ethernet cable to connect the computer to any of the four LAN ports as shown in the diagram. Connect the NETGEAR DSL modem router to its power supply unit (PSU) (Not shown in the diagram) and wait about a minute for it to boot up. Connect the DSL port of the NETGEAR modem router to the phone line, via the DSL Microfilter, as shown in the diagram.To configure your DSL modem router for Internet connection with Smart Wizard: If your router uses the old Smart Wizard user interface, see How to configure your NETGEAR router for cable Internet connection with Smart Wizard